Discussions 92
-
Photo is attached. I get a lot of errors where it extends way past where I mark to go. Here are some photos of the…
-
I am planning implants in the upper left and upper right quadrant for a patient. I am only allowed to plan either upper or lower…
-
If I try to make an upper and lower bite splint at the same time, nothing happens. It literally just says all done. My periodontist…
-
Hi, I am trying to add 0.5mm to the labial/buccal surface of anteriors and premolars, in the same anatomic shape, and print the model for…
-
I need help with work flow in following scenario after tryin 1) 3d tryin denture was designed in exocad and 3d printed . base fits…
-
Hello, I have been printing full upper arch NG as well as 6-11 only coverage. How is everyone getting the best design? When I do…
-
I designed a hybrid and all I need to do is adjust vertical and move the midline. I imported the new bite scan and aligned…
-
I need to make upper denture with following data 1) I have upper denture scanned with reline impression. Vertical dimension are good but anteriors teeth…
-
Do all of these videos have the annoying background music? It’s driving me insane. I’m going to have to get a refund for XOcademy if…
-
Please see the error. I get this when the space is tight and I cannot figure out what I need to adjust. Thanks John edit:…
-
We did a wash impression in a denture setup that was done in exocad. I got it aligned perfect and inverted the model. How can…
-
When doing a dual arch case, the max and mand teeth are always connected and cant be separated. For instance, if a pt has a…
-
Slowly but surely I am getting there. I get frequently the error I have posted a screenshot of. What is the issue I am causing?…
-
Once I have designed a screw retained substructure (eg bar) and then move on to design superstructure which I will bond to bar how do…
-
I’m trying to separate teeth from base wax-up but every time I’m facing this issue. A pop-up comes as the operation failed I attached the…
