Welcome to XOcademy Discussion Forums Cases Bite Splint Design

  • Bite Splint Design

     XOcademy updated 3 weeks, 3 days ago 3 Members · 3 Posts
  • chrisching.dds

    Member
    October 29, 2020 at 9:14 am

    Hey XOcadmey,

    I am having issues with a specific bite splint case. When I place the points to design the bite splint, it goes through the teeth. This in turns results in the splint being printed shallow and will not fit on the model. Any advice on how to fix this issue? Thank you in advance. Pictures below.

  • João

    Member
    November 8, 2020 at 3:40 am

    Hi, it seems to me that the design procedure is not finish yet. you need to merge and save.

  • XOcademy

    Administrator
    November 10, 2020 at 9:12 am

    @chrisching-dds , did you figure it out? I agree with @Bravo that you need to complete the merge. If the wizard isn’t guiding you to finish the case, go to Expert mode, then the bottom expert toolbar and there should be an icon with a checkered flag that says finish and merge. That should remove the bite splint bottom surface from the construction.

Log in to reply.

Original Post
0 of 0 posts June 2018
Now