Discussions 92
-
Custom Abutment, Screw Retained restoration. Abutment hole not created? To access this content, you must purchase XOcademy Forum Subscription, XOcademy Annual Membership, XOcademy Annual Membership…
-
If I scanned an implant with my generic implant scanbody and wish to switch later to a specific option such as a Dess Ti-Base, can…
-
Is it possible to design a denture without a buccal flange 3-3 upper or would I just have to trim off? To access this content,…
-
Anyway to create angled screw channels/custom when designing a hybrid/all-on-4? We’re using Straumann Variobases on the multi-unit abutments and there are a few implants that…
-
If the VD was too open in the bite that was imported into Exocad, can I reduce or close the bite virtually? To access this…
-
I used a 10mm tall TiBase in a crown design for #30. Could have used a 4. When I merge, the entire tibase sticks above…
-
After the secondary insertion step on a custom abutment design (screw retained) I never see the big yellow 0 degrees you show on the video.…
-
1 When I use cut intersections to improve contacts it produces no contacts, leaving small gap between multiple designs-is there a parameter setting to stop…
-
When done with a denture design, the output teeth are disabled so I can’t save them. This is true with Exocad generic etc. Any idea…
-
Has anyone tried and had success with the new automatic waxup attachment addition made to Plovdiv? I’ve tried a couple times, but the process failed.…
-
Now that the denture is successfully saved, can I please have more detail on how to print the set of teeth connected instead of individually?…
-
Hi Shawn, I have a case where budget is limited and the periodontist supplied universal abutments no charge to me or patient. Case is 22-27…
-
When I get sent to the Tooth Placement step, there is a red rectangle through my posterior teeth before I have moved anything. I can’t…
-
Doing a momobloc single arch denture. The Exocad Generic teeth are not an option in my menu. The other teeth do not export when I…
