Discussions 92
-
Can anyone help me figure out why my Preciso M200 mill suddenly will not recognize the end of a job and keeps cycling even though…
-
Is there a way to adjust the diameter of the bottom of a screw retained crown? My Ti base is fitting too loose. To access…
-
I am making a single arch denture using pontic wax-up. I reduce my merged monoblock in free form, and try to add in my saved…
-
Do you guys prefer Print or Mill for Night Guard/splints? To access this content, you must purchase XOcademy Forum Subscription, XOcademy Annual Membership, XOcademy Annual…
-
Once I have designed a monoblock try-in for a single arch denture using pontic waxup, how do u save the teeth and base separately? Is…
-
I am struggling with Model Creator – Implant models. I do not seem to be able to generate the gingival mask STL to print. I…
-
Do you design from multiple locations / workstations? I design primarily from two different workstations, and sometimes on a laptop- so three total different computers.…
-
I needed to make P/ acrylic with teeth missing in different areas -ur46 ul12. I started learning partial cad then after few hours realised this…
-
Hi I’m trying to create a snap on smile design to mill in acetyl resin I have found a YouTube video from exocad which uses…
-
Hey XOcadmey, I am having issues with a specific bite splint case. When I place the points to design the bite splint, it goes through…
-
My print job for printing a denture base is failing. The risers are printed but when the printer gets to the base it only prints…
-
If we have 2 types of implant scanbodies in one bridge, can exocad work with that? If not, what is the work-around? To access this…
-
The lower and Upper Jaw are in the same direction. How do I seperate them so I can align them? To access this content, you…
-
How can I design a bar over telescopic crowns? To access this content, you must purchase XOcademy Forum Subscription, XOcademy Annual Membership, XOcademy Annual Membership…
